Upgrading to Tecknaro 64-bit

Use this forum to ask questions about how to use Tecknaro, and to help answer other users' questions.
tecknaro_admin
Site Admin
Posts: 21
Joined: Sun Oct 17, 2010 6:37 pm

Upgrading to Tecknaro 64-bit

Postby tecknaro_admin » Sun May 13, 2012 1:53 pm

If you have been using Tecknaro version 1.0.2 or earlier on a Windows 7 system and are upgrading to the 64-bit version, please read this.

When you install Tecknaro 64, it is going to install into a different location than your previous copy of Tecknaro. This is because in Windows 7, 32-bit applications are installed into C:\Program Files (x86)\, while 64-bit applications are installed into C:\Program Files\.

In order to Tecknaro load all your previous work and also have Tecknaro find your license, you will need to copy your configuration, as well as your data files over to this new location.

Here’s how you do that: once the installer is finished, please copy the contents of

C:\Program Files (x86)\Tecknaro\Tecknaro_config
over to
C:\Program Files\Tecknaro\Tecknaro_config,
and copy the contents of
C:\Program Files (x86)\Tecknaro\Tecknaro_data
over to
C:\Program Files\Tecknaro\Tecknaro_data.

Tecknaro 64 should then start up using your existing configuration and data.

Return to “How Do I...?”

Who is online

Users browsing this forum: No registered users

cron